![]() |
|
![]() |
![]()
Riding Over / Around Streetcar Tracks
MY PHILOSOPHY - SMOOTH,
MAN, SMOOTH
I would suggest, as is the case with riding on metal grate bridges, you keep
very relaxed posture, and in so doing, try to be very smooth with anything you
do. A tire rolls quite nicely on ice. It's only when it suddenly turns, jerks,
brakes or accelerates that it slips (hills excepted). Also, when a bike is at
speed, it has natural gyroscopic tendencies... it wants to stay up. So, just
let it do it's thing, don't fight it or strong arm your bars.
NO SINGLE ANSWER FOR ALL SITUATIONS
My experience is there is no hard and fast rule about lane position, as the
conditions downtown vary dramatically from one intersection and street to the
next. Sometimes between the rails is the place to be, especially if there is
hairy traffic activity going on in the lanes on either side. Sometimes outside
the rails, on one side or the other, is the place to be, esp if there is no
hairy traffic on that side, and if the grates or drains or mahole covers --
or whatever those things are that are regularly spaced between the rails --
are consistently sunk two inches below the road surface (in which case it's
kathump.... kathump... kathump... ka-clang, something's shaken loose... kathump...
).
Very often, my ride down along street car tracks, e.g. Queen Street in the Beaches,
involves switching positions many times... middle... side... middle... side
again.... other side... etc.
HOW I CROSS TRACKS
When transitioning across a streetcar track, don't be gradual. Now, don't be
aggressive either, cuz as mentioned earlier, smooth is your friend. But take
a good angle, at least 30 degrees. The idea is, when you have a good angle,
your tire is not running along the rail very long, it's actually just stepping
across it briefly. This way, if worst happens, and the tire slips on the rail,
it's on the rail for only a short moment before it's on asphalt again, so you'll
only get a scare, not a dump. Remember, be "smooth" while crossing
the track. e.g. while on asphalt, make the change in the motorcycle's direction
to point cross the rail... then hold a straight line until crossed over the
rail, then straighten out in direction of the road again.
Dare I try an ASCII diagram?
Good Example: Crossing from outside the rails to between:
--YOU->---->------\
\
**RAIL**************\******************
\
\----->------>---
**RAIL*********************************
Look how briefly your tires are on the
rail. Worst case, you get a little slip, and that's all. Remember the bit about
being loose, smooth and relaxed? If it slips, just sit comfy, DON'T fight the
bars, and let the bike recover itself, it will quickly. If you need to cross
several rails at once, same suggestions apply, just do one rail at a time.
Dangerous Example: crossing
gradually:
--YOU->--->-___ **RAIL*********~~~->-___***************Look how much longer you are on the rail. Your tires will each rotate almost a full revolution before getting off the rail again. This is enough to cause a serious slide if slippery.
~~~~-->------>-
**RAIL*********************************
Stylz is a member
of the Zen Riders
|
![]()

© 2002-2003 Intruder Alert.Ca